6
1.
Open the parts bag labeled “FRAME ASSEMBLY.”
Press a 2” x 3” Inner Cap (24) into the Main Upright
(3) in the indicated location.
Press a 2” x 3” Inner Cap (24) into each end of the
Stabilizer (5).
Inset three 3/8” x 3 3/4” Carriage Bolts (52) and a
3/8” x 5” Carriage Bolt (82) into the indicated holes in
the Stabilizer (5).
Attach the Main Upright (3) to the Stabilizer (5) with
the two indicated 3/8” x 3 3/4” Carriage Bolts (52) and
two 3/8” Nylon Locknuts (50).
Do not tighten the
Nylon Locknuts yet.
1
24
5
52
82
50
24
24
3
52
2.
Press 2” Square Inner Caps (33) into the Leg Lever
(29) and the front leg on the Base (8) as shown.
Note: Do not insert the 2” Square Inner Cap fully
into the Base; it will need to be removed later to
attach the Curl Post (not shown).
Align the bracket on the Base (8) with the holes in the
Main Upright (3). Attach the Base with a 3/8” x 4” Bolt
(65), a 3/8” Flat Washer (55), and a 3/8” Nylon
Locknut (50).
The Bolt must be inserted from the
side shown. Do not tighten the Nylon Locknut yet.
Insert two 5/16” x 3” Bolts (78) into the Base (8) and
the Main Upright (3) and finger tighten a 5/16” Nylon
Locknut (81) onto each Bolt.
Do not tighten the
Nylon Locknuts yet.
Before beginning assembly, make sure you
have read and understood the information on
page 5. This brief introduction will save you
much more time than it takes to read it!
2
65
50 55
78
33
29
8
Front Leg
Bracket
3
81
3
3. Attach the Foot Plate (4) to the Base (8) with a 3/8” x
5 1/2” Bolt (57) and a 3/8” Nylon Locknut (50).
57
4
8
50
Frame Assembly
