6. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 29). To protect the
floor or carpet from damage, place a mat under the treadmill.
7
5. Insert two Handrail Bolts (104) with Handrail Spacers
(106) into the right Upright (99) and the right Handrail
(83). Be careful not to pinch the wires. Make sure
that the Handrail Spacers are flush against the right
Upright, with the thick sides facing the center of the
treadmill, as shown in the inset drawing. Next, lift the
right Handrail (83) slightly and align the Bolts with the
holes in the Handrail. Thread the Bolts into the
Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Then, tighten all four Handrail Bolts (104).
5
104
106
Thick
Side
99
106
4. Cut the plastic tie holding the Upright Wire Harness (119)
in the right Upright (99). Have a second person hold the
Handrails (83) near the Uprights. Connect the Upright
Wire Harness to the wires extending from the Console
Base (130). The connectors should slide together
easily and snap into place. If they do not, turn one
connector and try again. Then, insert the connectors
and the Upright Wire Harness into the hole in the right
Upright.
Set the Handrails on the Uprights, being careful not to
pinch the wires.
119
99
130
83
4
83
Summary of Contents for 7200r Treadmill
Page 33: ...33 NOTES ...
