FLUSH MOUNT
- Remove rubber ring (Q) from canopy (C). (See Fig. 2c)
- Remove the yoke screws and lock washers (K) which correspond to
the holes in the canopy (C).
- Position canopy (C) over the holes on motor (I) and secure with the
same screws and lock washers (K) removed in the previous step.
Be sure to place the rubber bushing (D) between the canopy (C)
and the motor (I).
C
C
Q
I
Fig. 2d
Fig. 2c
K
D
Model no.
052-2231
5
Model no.
052-2231-4
A
ssembly
Step 1 - DOWNROD MOUNT
- Using a screwdriver, loosen the 2 upper jam screws (J) on the
yoke.
- Position downrod (G) inside canopy (C).
- Route wires exiting yoke on motor (I) through downrod (G) and
ceiling canopy (C).
- Position downrod (G)/canopy (C) into yoke and align holes in yoke
and downrod (G).
- Insert bolt (H) through hole in yoke and downrod (G). Be careful
not to damage or cut the fan wires.
- Install flat washer (H) and bolt (H). Secure with cotter pin (H)
through hole in the end of the bolt (H).
- Secure downrod (G) in position by tightening the 2 upper jam
screws (J).
NOTE: All set screws must be checked and
retightened where necessary, before and after installation.
CAUTION
H
H
Yoke
Fig. 2a
Fig. 2b
J
J
C
G
J
Yoke
Do not
loosen the two
lower jam screws
I
