9
turn off after 15 minutes of operation. Press the jet pad again to activate the low- or
high-speed pump for another 15 minutes of operation.
TEMPERATURE ADJUSTMENT
The Hot Tub temperature is controlled by pressing the UP or DOWN temperature control
pad. The set temperature is indicated by a flashing display. Keep pressing the pad to
raise or lower to the desired temperature. The display will automatically revert to show
the actual water temperature within a few seconds. The heater and low-speed pump will
automatically activate any time the actual water temperature falls below the set
temperature. The maximum temperature setting is 104
F.
LIGHT
Press the light pad to activate and deactivate the Hot Tub light. The light will
automatically turn off after some period of operation.
SAFETY FEATURES
Overheat Protection ( Hot Tub is deactivated )
If your Hot Tub should overheat, the display on the top-side control will flash "OH". In
such a condition, DO NOT ENTER THE WATER. Turn off all power to the Hot Tub
and contact your dealer or service organization.
Flow Switch Detection
If a pressure switch malfunctions, the display will show "FL". Contact your dealer or
service organization. This protection indicates there is not enough water running through
the heater in order for it to work properly.
Open Sensor ( Hot Tub is deactivated )
If the high-limit sensor or water temperature sensor malfunctions, the display will show
"SN". Contact your dealer or service organization.
NOTE: Do not attempt to service these controls. There are no user serviceable
parts inside the power pack. Contact your dealer or service organization
for assistance.
OPERATING INSTRUCTIONS
If your Hot Tub is equipped with the Brett BL-60 Controls, as shown below, please refer
to the enclosed Brett manual for operation of the top-side controls. Refer to pages 3-10,
14-19.
Summary of Contents for Nordic Hot Tubs
Page 1: ...INSTRUCTION MANUAL ...
