10
NORDIC
period, and then switch on the tool. The burr will form a non-slip bond with the outer edge of the sand
paper felt. This will avoid premature wear. If one point has become worn, pull off the sandpaper, turn it
120° and place it on again.
VARIABLE SPEED CONTROL
The variable speed feature of this tool enables the speed to be adjusted
according to the accessory being used and material being cut, scrapped or
sanded. The speed dial is numbered “1” through “6”, with position “1” being
the lowest speed and position “6” being the highest speed.
SWITCH ON AND OFF
To turn the tool ON, push the on/off switch forward. To turn it OFF, push the
switch backward.
OPERATION FOR WORKING
Do not touch the gear box after prolonged use; it could be very hot.
The removal rate and the sanding pattern are determined by the choice of
sanding sheet and the work surface. Apply uniform sanding pressure to
extend the life of the sanding sheets.
• Intensifying the sanding pressure does not lead to an increase of the sanding capacity, but instead it increases wear
on the machine and the sanding sheet.
• Use only the tip or an edge of the sanding sheet for precise sanding of edges, corners and hard to reach areas.
• When selectively sanding on one spot, the sanding sheet can heat up considerably. Remove the tool from the
surface periodically to permit the sanding sheet to cool down.
• A sanding sheet that has been used for metal should not be used for other materials.
• Use only original sanding accessories. For sanding, always connect dust extraction.
B. SCRAPING
The tool is suitable for scrapping and removing surface coverings. For scraping, select a high speed setting.
• To remove surface covers, place the scraping blade vertically on the work piece.
• Switch the tool on and cut down through the covering.
• Place the tool at a flat angle (not over 20°) and apply alight forward pressure to remove the covering.
C. CUTTING
Saw blades are ideal for making precise cuts in tight areas, close to edges or flush to a surface.
• Select the lowest speed for making initial plunge, start off at lowest speed for increased control. After making your
initial cut, you can increase speed for faster cutting ability.
