ENG
A N O R D I C B R A N D
.
The ventilation pipe must not be distorted or be bent over 45°.
Important notice
The length of the ventilation pipe must be 280-1500 mm, the length is based on the specifications of the product. Do
not use extension pipes or replace it with a different type of pipe, or this may cause a malfunction. Do not block the
ventilation outlet, otherwise it may cause overheating.
Maintenance and cleaning
Before cleaning and maintenance, turn the product off and unplug the power plug.
Clean with surface with a wet soft cloth. Don't use chemicals, such as benzene, alcohol, gasoline. The surface could
be damaged or the whole product could be damaged.
When the filters are filled with dust, the effectiveness will be reduced. Be sure to clean the filters every two weeks
1. Upper filter
2. Screws
3. Filter protection
4. Lower filter
Pull out the filter protection and take out the upper filter by removing the screws. Pull out the lower filter.
Put the filters in about 40
℃
/ 104
℉
warm water with a mild detergent. Rinse clean. Dry them in the shade. Put the filters
and the filter protection back on the device.
Storage
1. Empty the water (See the drainage instructions).
2. Turn on the device, and set it to low fan speed until the device is dry.
3. Turn off the device, unplug the power plug, re-plug the water plug and the drainage cover. Remove the ventilation pipe.
4. Cover the product with a plastic bag to protect it from dust. Put it in a dry place, keep it out of reach of children.
5. Remove batteries from the remote control.
Drainage instructions
This product has two drainage methods: manual drainage and continuous drainage.
Manual drainage:
1. To empty the water, turn off the product, and unplug the power plug.
Note: Move the product carefully, to avoid internal water leakage.
2. Place a water container below the drainage hole (8).
3. Unscrew the drainage cover and unplug the plug, the water will flow into the water
container.
Note 1: you can tilt the product slightly to empty more water.
Note 2: if the water container can’t hold all the water, re-plug until you emptied the
water container.
4. When it has been emptied of water, re-plug and screw back the drainage cover.
