Nordic ID 811-4A, Quick Manual

Page: 9 / 16

9
LASER BATTTERY AC ADAPTER
MEDICAL DEVICES
POTENTIALLY EXPLOSIVE
ENVIRONMENTS
SAFETY PRECAUTIONS
Nordic ID Morphic mobile computers,
equipped with 1D laser scanner, are
classified as Class 2 Laser products having
1mW power and 650nm wavelength. The
laser scanner uses a low power, visible
laser diode. As with any very bright light
source, such as the sun, the user should
avoid staring directly into the light beam.
Momentary exposure to a Class 2 laser is
not known to be harmful.
The NORDIC ID Morphic fulfils the
regulatory requirements as follows:
Complies with 21CFR1040.10 and 1040.11
except for deviations pursuant to Laser
Notice No. 50, dated June 24, 2007.
IEC/EN 60825-1:2007
用错误型号电池更换, 会有爆炸的危险, 务必
按照说明处置用完的电池
Use only the following Varta EasyPack
Recahargeable Li-Polymer 3,7V battery
models being intended for your Nordic ID
Morphic:
• EZPack XL (2260 mAh / 8,4Wh)
• EZPack L (1130 mAh / 4,2 Wh)
Note! Using some other battery type or
model for powering your Nordic ID Morphic
than those mentioned above may cause a
battery explosion.
Do not disassemble the battery.
Do not short circuit the battery’s electrical
contacts.
Do not expose the battery to direct sunlight
or other heat sources.
Dispose the battery in ecologically sound
manner and according to local laws and
regulations.
• Use only AC adapters approved by
Nordic ID. This device is intended for use
with Nordic Power S024EM0520300 AC
adapter.
• Do not use the AC adapter for any other
purposes than for charging the Nordic ID
Morphic rechargeable batteries.
• Check the mains voltage against those
specified in the AC adapter before
plugging to mains socket.
• Use the AC adapter indoors at normal
room temperatures.
To avoid potential interference from Nordic
ID Morphic it shall be operated (, and kept) a
minimum of 20 centimetres (8 inches) from
a medical device such as a pacemaker,
hearing aid, or cardioverter-defibrillator, in
every situation.
Switch off your device when in area with
potentially explosive atmosphere. Sparks in such
areas could cause fire or an explosion. Potentially
explosive environment include areas where the
air contains chemicals or particles such as dust
or other powders. Potentially explosive areas are
often, but not necessarily always, clearly marked.
Obey all signs and instructions.
DANSK LASERLYF! SE IKKE IND I STRÅLEN! KLASSE 2 LASER!
DEUTSCH LASERSTRAHLEN! NICHT DIRECT IN DEN LASERSTRAHL SCHAUEN!
LASER PRODUKT DER KLASSE 2!
ENGLISH LASER LIGHT! DO NOT STARE INTO BEAM! CLASS 2 LASER!
ESPAÑOL LUZ LASER! NO MIRE FIJAMENTE EL HAZ! PRODUCTO LASER DE
LA CLASE 2!
FRANCAIS LUMIERE LASER! NE PAS REGARDER LE RAYON FIXEMENT!
PRODUIT LASER DE CLASSE 2!
ITALIANO LUCE LASER! NON FISSARE IL RAGGIO PRODOTTO!
NEDERLANDS LASERLICHT! NIET IN STRAAL STAREN! KLASSE-2 LASER!
NORSK LASERLYS! IKKE STIRRINN I LYSSTRÅLEN! LASER, KLASSE 2!
PORTUGUÊS LUZ DE LASER! NÃO FIXAR O RAIO LUMINOSO! PRODUTO LASER
DA CLASSE 2!
SUOMI VARO LASERSÄDETTÄ!
ÄLÄ SUUNTAA SÄDETTÄ SILMIIN! LASER,
LUOKKA 2!
SVENSKA VARNING LASERSTÅLNING! STIRRA EJ IN I STRÅLEN! KLASS 2
LASER!