Place the Blade Sections face down and slide together as shown. A - Feed 1”
long bolts through 4 - fastening points. Attach washers and nuts, then finger
tighten only. Align Blade Sections and tighten fully.
WASHERS
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
1” LONG
X 4
X 4
3” LONG
IMPORTANT!
TIGHTEN FULLY
IMPORTANT!
TIGHTEN FULLY
TAB
Feed 3” long bolts through (2) holes in each End Cap and Blade Section.
Attach washers and nuts, tighten fully.
Place (8) Blocks over ends of the 3” long bolts as
shown. (Keep blocks and 3” long bolts in place for
the next step.)
1
2
4
3
LOCKING FACES OF LOCK
NUTS MUST ALWAYS BE IN
AGAINST THE SURFACE YOU
ARE FASTENING!
X 2
3/4” LONG
Position the Blade for front access. Screw 3/4”
self tapping Phillips screws into pilot holes at
(2) places as shown on the Blade front surface.
BLADE
X 8
3” LONG
PAGE - 2