w w w . h a w k e y e e l e c t r o n i c s . c o m
If you think that the transom mount transducer is not suitable for your installation,
return to the place of purchase and exchange for the thru-hull
(D10DX.06T).
You
can also visit our Customer Service Center at www.hawkeyelectronics.com to
contact us or to complete a transducer exchange request to exchange the
transducer for one that is specialized for your vessel. You may also call 888-
766-7276 to inquire about exchanging the transducer.
INSTALLING THE DISPLAY
Tools & Supplies Required for Installation
•
Electric Drill
•
2” Hole Saw
•
Wire Connectors Suitable for Connecting the Power Wire to Your Vessel
•
Wire Cutting/Crimping Tool
•
Marine Sealant/Caulk
STEP 1
Installing the Display
1. Find a location on the boat that will allow clear viewing of the display. Keep
in mind that the wires for the transducer and power must reach the mounting
location.
2. After finding the right location, mark a 2-inch hole.
(If your boat has a pre-cut
hole in the dash panel, simply remove the hole plug and proceed to Step 5.)
I
MPORTANT
:
Check behind the desired cutting area for wires, switches, etc. that
may be damaged during cutting. If these obstructions are present,
use masking tape to hold them out of the way during cutting.
3. Cut out the 2-inch hole using the 2” hole
saw.
4. Seal any exposed wood with a marine
sealant.
5. Insert the display from the front of the panel,
feed the wires through the bracket and install
the bracket and locking nut from the rear of
the panel. Make sure that the face of the
display is rotated upright and aligned to your
satisfaction for easy viewing from the
vessel’s helm.