Norco BIS-6592LC, User Manual, Page: 33 / 83

BIS-6592LC
LED Screen Control Hardware Platform supporting 1080PHD Display
25
Chapter 3 Computer Installation and Use
Before the installation of computer peripheral accessories
Please follow the safety principles below, it will prevent the computer from potential damage
and ensure personal safety.
Please make sure your computer is disconnected with the powe supply.
Only licensed service technicians can carry out maintenance on your computer. The
warraty is not within the scope if you open and repair it without the company
’
s authorization
Disconnect the computer power connector carefully, the power connector has foolproof
design, Please must take care and protect the connector pins.
Before you touch any components of computer, please make sure your hand touch an
unpainted metal surface, it will remove static electricity during the assembly process. During
operation, please keep touching the unpainted metal surface, it will be useful for static
electricity discharge.
3.1 Install computer external parts
3.1.1 DVI Interface Connection
Both the motherboard and the LED controller board have one DVI port. Motherboard will send
video signal to LED controller card. DVI interface of LED controller card is used to receive
video signal, then it will send the RJ45 video signal to the large LED screen.
3.1.2 COM Device Connection
Connect COM devices to the computer serial ports.
3.1.3 PS/2 Keyboard and Mouse Connection
1. Connect the 6PIN PS/2 connector to the computer PS/2 interface
2. Connect the PS/2 mouse interface to the PS/2 mouse connector
3. Connect the PS/2 keyboard interface to the PS/2 keyboard connector