Noraxon U.S.A., Inc.
TeleMyo 2400T V2
Steady (Not blinking)
– The Status indicator glows steady when its battery charge has reached a critical
level. When this occurs, it is important to recharge the transmitter’s internal battery to continue
satisfactory operation, or use an external battery.
2.
Battery Charge Indicator
The battery ‘CHARGE’ indicator will only display when the transmitter’s internal battery is being
recharged. When recharging, this indicator will initially blink and then glow steady. When the
indicator goes off, charging is complete. For instructions on how to recharge the batteries, please refer
to page 14 of this manual.
3.
Battery Charger Connector is the port to which the battery charger power source is connected.
This is only active when the unit is switched to the ‘off’, “0”, or ‘charge’ state.
The transmitter cannot be used while it is recharging. To avoid a
potential electrical shock, do not have leads attached to a patient while it
is being charged.
4.
On/Off (Recharge) Switch
In the “0” or charge position, the device is turned off. It is also possible to charge the batteries in this
position. In the “1” position, the instrument is on and EMG measurements may be taken.
5.
Antenna Connector is the port to which the Antenna is connected.
When in use for extended periods of time, position the transmitter’s
antenna away from any exposed parts of the body, especially the face or
eyes.
Do not operate the transmitter unless the antenna is connected. If the
antenna is not connected, the radio may be damaged.
Left Side
1
2
1.
Sync Input Connector
When using multiple transmitters, it is necessary to synchronize all units using the transmitter-to-
transmitter Sync cable. The cable makes an attachment between the Sync Output of one transmitter to
the Sync Input of the next. For instructions on how to use multiple transmitters, please refer to page 4.
P-2308TV2 Rev G (06-06-11)
28