6505 Gayhart St., Commerce, CA 90040 | Phone: 800.686.6672 | www.noralighting.com | e-mail: [email protected]
Instructions subject to change without notice. © 2018
080918P2
Installation Instructions
NHSIC-4 SERIES JUNCTION BOX FIXTURE
READ PRIOR TO ATTEMPTING INSTALLATION
ALWAYS TURN OFF MAIN POWER BEFORE INSTALLATION
INSTALLATION SHOULD BE CARRIED OUT BY YOUR LOCAL ELECTRICIAN
HoUsing instRUctions:
1. Loosen screw to adjust the bar.
2. Screw back to set the bars. (Max span: 24”)
Loosen hanger bar screw.
Adjust one hanger bar to desired
length.
Secure and screw back the hanger bars.
Adjust the other hanger bar to
desired length also.
to access DRiVeR:
1. Remove trim.
2. Loosen 4 screws.
3. Slide the inner boxes to access the driver.
4. Slide back.
5. Tighten screws when box is in desired position.
6. Replace trim.
Remove trim.
Loosen 4 screws.
Slide inner box to access the
driver.
to access WiRing coMpaRtMent:
1. Remove trim.
2. Remove 4 screws.
3. Remove fixture box.
4. Slide and remove driver box.
5. Replace driver box.
6. Replace fixture box.
7. Tighten screws.
8. Replace trim.
Remove trim.
Slide driver box.
Remove driver box.
Loosen 4 screws.
Remove fixture box.
