5
NookBox
Installation Guide
AC Powered Indoor Siren
ZigBee Network Setup
ZigBee Device Guideline
ZigBee is a wireless communication protocol that is reliable and has low power consumption and high transmission efficiency. Based on
IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network and coordinated for data exchange and signal
transmission.
Due to the fundamental structure of ZigBee network, ZigBee device will actively seek and join network after powering on. Since performing a
task in connecting network may consume some power, it is required to follow the instructions to avoid draining battery of a ZigBee device.
• Ensure your ZigBee network router or coordinator is powered on before powering on the ZigBee device.
• Ensure the ZigBee network router or coordinator is powered on and within range while a ZigBee device is in use.
• Do not remove a ZigBee device from the ZigBee network router or coordinator without powering down the ZigBee device.
Joining the ZigBee Network
As a ZigBee device, the Indoor Siren needs to join a ZigBee network to send and receive alarm signal. Please follow the steps below to
join the Indoor Siren into the ZigBee network.
1. Plug the Indoor Siren into a power outlet.
2. Press and hold the function button for 10 seconds as the Siren resets and starts searching for existing ZigBee network.
Please make sure the permit-to-join feature on the router or coordinator of your ZigBee network is enabled.
3. If the Indoor Siren successfully joins a ZigBee network, the LED Indicator will flash twice to confirm.
4. After joining the ZigBee network, the Indoor Siren will be registered in the security system in the network automatically. Please
check the security system control panel or CIE (Control and Indicating Equipment) to confirm if joining and registration is successful.
5. For SRV-23B-ZBS, after joining the ZigBee network, if the Siren loses connection to its current ZigBee network, the LED indicator will
flash every 20 minutes to indicate. Please check your ZigBee network condition and siren signal range and correct the condition
Removing Device from ZigBee Network (Factory Reset)
To remove the Siren from current ZigBee network, the Siren must be put to Factory Reset to complete device removal. Factory Reset function
will clear the device of its stored setting information and prompt the Siren to search for new ZigBee network.
Before removing device, make sure the Siren is within current ZigBee network signal range.
1. Press and hold the function button for 10 seconds, then release the button to reset Siren.
2. Upon reset, the Siren will clear current ZigBee network setting and transmit signal to ZigBee coordinator to remove itself from
current ZigBee network. It will then actively search for available ZigBee network again and join the network automatically.
ZigBee Router Device Capacity (SRV-23B-ZBSR)
The Siren model with Router function (SRV-23B-ZBSR) allows other ZigBee devices to join the ZigBee Network through the Router.
It has maximum capacity of 40 ZigBee devices or routers.
