6
NookBox
Installation Guide
Glass/Break Detector
Installation
The Glass Break Detector should be mounted on ceiling or wall. There should be no obstacle between the Detector and the window
protected. The Detector back cover has mounting knockouts which can be broken for screw mounting. Alternatively, you may also mount
the detector with double side adhesive tape provided.
Mounting Location
• Mount away from sound source, such as speaker, air condition or motor.
• Mount with as much distance from window or door as possible to avoid external sound interference.
Screw Mounting
1 Break through the knockouts on back cover and use them as template to mark position on wall/ceiling.
2 Drill holes at marked location and screw the back cover onto the wall/ceiling, insert wall plug if needed.
3 Replace the Detector main body onto the back cover. Make sure the cover is properly closed and the device is fixed to the wall tightly.
Adhesive Tape Mounting
When using provided double side adhesive tape, make sure to install the detector on flat surface.
Do not install on uneven surface or location with cracking paints.
1 Clean both the detector back cover and mounting location with suitable degreaser.
2 Apply the double side adhesive tape to back cover of detector, then apply to mounting location.
<NOTE>
When mounting with double side adhesive tape, the tamper protection for mounting location removal will be disabled. Protection from cover opening is still
available.
