Nonin CO-Pilot H500, Operator'S Manual

Page: 28 / 68

22
System Components and Set Up
Connect/Disconnect a Sensor to the Signal Processor
1. To connect:
a. Flip the clear lock on the signal processor back to expose the
connection port ( Figure 9.A ).
b. Insert the sensor connector into the signal processor connection port
( Figure 9.B ).
c. Flip the lock over the sensor connector and click it into place ( Figure
9.C ).
Figure 9. Connect Sensor to Signal Processor
2. To disconnect:
a. Flip the clear lock on the signal processor back to disengage the lock
from the connector.
b. Grasp the connector and remove the sensor from the signal
processor.
Replacing the Lock on the Signal Processor
NOTE: Replacement locks may be ordered if the lock is lost or damaged.
1. Align the lock hinge with the connector end of the signal processor.
( Figure 10.A ).
A
B
C