5
REMEMBER
to turn off the power. Follow the steps below to
hang your fan properly.
1. Remove the clevis pin, cotter pin and set screws from the top
of the motor assembly (see Fig. 5).
2. Route wires exiting from the top of the fan motor through the
coupling cover, canopy and then through the ball/downrod
(see Fig. 5).
NOTE:
If a longer downrod (not included) is needed, take out
the screw located in the hanger ball, lower the hanger ball and
remove the pin, remove all 3 pieces from the downrod and
assemble them onto the new longer downrod before proceeding
to step 2.
3. Align the holes at the bottom of the downrod with the holes in
the coupling on top of the motor housing (see Fig. 5). Carefully
insert the clevis pin through the holes in the collar and
downrod. Be careful not to jam the clevis pin against the
wiring inside the downrod. Insert the cotter pin through the
hole near the end of the clevis pin until it snaps into its locked
position, as noted in the circle inset in Fig. 5.
4. Tighten two set screws at top of the fan motor collar firmly
and evenly (see Fig. 5).
5. Carefully lift the fan assembly up to the ceiling mounting
bracket and seat the hanger ball in the mounting bracket
socket. Make sure the tab on the mounting bracket socket is
properly seated in the groove in the hanger ball (see Fig. 6).
This will help to balance the ceiling fan.
6. Secure the safety cable to the building structure using a hook
screw (included).
Hanging the Fan
Warning: Failure to properly install cotter pin as noted in
step 3 could result in fan loosening and possibly falling.
!
Motor wires
Ball/downrod
assembly
Canopy
Pin in locked
positioon
Motor collar
Coupling cover
Set screws
Cotter pin
Clevis pin
Fig. 5
Fig. 6
Warning: The tab in the ring must rest in the groove of the
hanger ball as in Fig. 6. Failure to properly seat the tab in the
groove could cause damage to wiring.
!
Groove
Tab
Safety cable
Installing Your Fan
Turn off power at breaker box to
avoid possible electric shock.
Use metal outlet box (sold separately)
suitable for fan support. Secure outlet box
directly to the building structure using wood
screws (included). Outlet box must support
35 lb (15.9 kg) minimum.
Install mounting plate to outlet box
in the ceiling using the mounting
screws provided with the outlet box.
Fig. 3
Fig. 2
Mounting bracket
Outlet box
Mounting screws
Fig. 4
