To Replace a Fuse:
USER SERVICING INSTRUCTIONS
Power cord fuse replacement (1 replaceable 3 A, 125 V fuse is located in the plastic bag):
5. Insert spare replacement fuse. Close fuse cover by sliding fuse access cover
CAUTION:
To reduce risk of fire, replace fuse in power cord with only 3 A, 125 V fuse.
Do not replace attachment plug. Contains a safety device (fuse) that shall not be removed.
Caution
a) Before using or reusing, inspect product carefully. Discard any products that have cut, damaged,
or frayed wire insulation or cords, cracks in the bulb holders or enclosures, loose connections,
b) When storing the product, carefully remove the product from wherever it is placed to avoid any
or exposed copper wire.
Use and care instructions
undue strain or stress on the product conductors, connections, and wires.
Discard product if the attachment plug is damaged.
To Replace a Bulb:
If the bulb base of the replacement bulb does not fit in the string: (as shown below by the Figs.)
b) Straighten the two wires on the end of the original burned-out bulb and remove the bulb base.
c) Straighten the wires on the end of the new bulb and remove
a) Pull the reflector out.
the bulb base.
on the cord tag near the connected product’s receptacle.
Connecting Sets End to End
(for connect multiple products)
When multiple products are connected together, do not exceed the lowest of the indicated maximum wattage
e) Insert the reflector into the base.
bulb to the hook on bulb base).
bulb base and bend the wires back (always match the long lead of new
d) Guide the two wires of the new bulb into the two holes of the original
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding the fuse cover towards the blades of the attachment plug.
3. Turn the fuseholder over or push on the fuse for removal.
4. Risk of fire. Replace fuse only with 3 A, 125 V fuse.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Unlock the burned out LED bulb by lifting the hook.
4. Replace bulb with only 3.0 Volt, 20 mA push-in type LED bulb (provided with product). Always
5. Lock the hook of bulb base by pushing lock down into the tab.
3. Pull bulb and plastic base straight out of bulb holder.
match the hook to the tab.
Hook
Tab
Unlock
Lock
towards the cord.
