Nolan N60-6, Safety And Instructions For Use

Page: 15 / 96

15
N60-6
INSTRUCTIONS FOR USE
2 CHECKING AND ADJUSTING THE STRETCH
Check that the PINLOCK
®
inner visor has been correctly fitted by opening and closing
the visor and ensuring that they do not move with respect to each other.
Should the PINLOCK ® inner visor not be tightly fixed to the visor, simultaneously move,
gradually and not excessively, both external adjustment levers upwards, to increase
the stretch (Fig.3). The maximum stretch is achieved when the pin adjustment external
levers are positioned outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
®
visors and inner visors may cause reduced visibility and
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
®
inner visor to prevent it from
moving and scratching both surfaces.
- If, in use, the helmet visor fogs up and/or condensation forms between the visors,
check that the PINLOCK
®
inner visor is both correctly fitted and stretched.
- An excessive and early stretch of the PINLOCK
®
inner visor may result in exces-
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform future adjustments.
- Intense sweating/breathing, use in particular weather conditions (low tempera-
tures, high humidity, sudden changes in temperature or heavy rain) and/or intense
and prolonged use may affect the performance of the PINLOCK
®
inner visor, caus-
ing fogging or formation of condensation. In such cases, to restore the system ef-
ficiency after using the helmet, remove the PINLOCK ® inner visor from the helmet
visor and leave it to dry in warm and dry air. The same procedure must be applied
to the helmet, which should be left to dry to remove any humidity that may have
formed as a result of the conditions described above.
3 DISASSEMBLY
3.1 Disassemble the visor equipped with the PINLOCK ® inner visor (see instructions
above).
3.2 Widen the visor and release the PINLOCK
®
inner visor from the pins (Fig.5).
3.3 Release the visor.
4 MAINTENANCE AND CLEANING
- Remove the PINLOCK
®
inner visor from the visor. Using a damp and soft cloth,
gently clean it with mild liquid soap. Rinse off all the soap under running water.
- Leave the visor to dry in warm and dry air without wiping it.
- To preserve the visor’s condition over time, leave the helmet to dry in a ventilated
and dry place with the visor open after use. Keep it away from heat sources and
store it in a place away from direct light.
- Do not use solvents or chemical products.
VISION PROTECTION SYSTEM (VPS) - (VPS-15)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™ (*) polycar-
bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. It is very
simple and practical to use: just lower it to activate it or lift it to remove it from your field
(*) LEXAN is a trademark of SABIC.