420
1610
940
400
466
466
1610
420
Add a letter after the product code to specify the
version required, for example
Ö19-20
A
:
A = Armrests (Ö19-20 and Ö19-22 versions only)
M = Ground-mounted armchair with extended support
posts for casting in concrete 40 cm beneath the
surface
N = Attachable version with base edge extended for
bolting into the surface
Ö19-27
Parco bench
Delivery Specification:
1 seat,
2 leg supports (with fixed support post or swivel),
8 screws and washers for attaching the seat and
backrest to the supporting posts.
BACKLESS BENCH
ASSEMBLY INSTRUCTIONS
Turn the bench upside down,
being careful to protect the
wooden parts during
installation. Using a
screwdriver with an H6 bit,
secure the supporting post to
the underside of the seat with
the screws and washers
included (MK6S M10 x 16 +
FBB M10).
Installation with M10 bolts (‘N’ version):
The base plate has been made with holes to secure it
to the surfaces with M10 bolts.
Installation on a wooden surface (‘N’ version): Use
French-style woodscrews to attach the base plate to
the wood.
Installation on cobbles or paving stones (‘N’ version):
Anchor the cobbles or paving stones in a cast concrete
base without allowing any levelling sand to come
between the stones and the concrete. Drill holes in the
surface sized to accommodate expander bolts. A
chemical anchor may also be used.
Installation on concrete (‘N’ version): Attach with
expander bolts or a chemical anchor as instructed
above. Attaching with expander bolts makes it possible
to remove and reattach the bench as required.
Ground-mounted installation (‘M’ version): Prepare the
ground with holes circa 40 cm in diameter to a frost-
free depth. The C-C_ distance between the holes
should be 94 cm
.
Fill the hole with frost-resistant
material so that the hole is not deeper than 50 cm.
Turn the bench upright and position the supporting
posts in the hole. Ensure that the armchair seat is level
in position as well as level on all sides. The distance
between the seat’s front edge and the ground beneath
should be 45 cm..
The supporting post should be cast in the concrete,
leaving a gap of 5 cm between the top of the concrete
and the ground surface to be filled in with surface
material.
sid 4/7
Parco