465
1610
940
940
400
465
649
785
Add a letter after the product code to specify the
version required, for example
Ö19-20
A
:
A = Armrests (Ö19-20 and Ö19-22 versions
only)
M = Ground-mounted armchair with extended
support posts for casting in concrete 40 cm
beneath the surface
N = Attachable version with base edge
extended for bolting into the surface
Ö19-26
Backed Bench
Delivery Specification:
1 seat and backrest (with or without armrests),
2 leg supports,
8 screws and washers for attaching the seat and
backrest to the supporting posts.
BACKED BENCH ASSEMBLY
INSTRUCTIONS
Turn the bench upside down, being
careful to protect the wooden parts
during installation. Using a
screwdriver with an H6 bit, secure
the supporting post to the
underside of the seat with the
screws and washers included
(MK6S M10 x 16 + FBB M10).
Installation with M10 bolts (‘N’
version):
The base plate has been made
with holes to secure it to the
surfaces with M10 bolts.
Installation on a wooden surface
(‘N’ version): Use French-style
woodscrews to attach the base
plate to the wood.
Installation on cobbles or paving
stones (‘N’ version): Anchor the
cobbles or paving stones in a cast
concrete base without allowing any
levelling sand to come between the
stones and the concrete. Drill holes
in the surface sized to
accommodate expander bolts. A
chemical anchor may also be
used.
Installation on concrete (‘N’ version): Attach with expander
bolts or a chemical anchor as instructed above. Attaching
with expander bolts makes it possible to remove and
reattach the bench as required.
Ground-mounted installation (‘M’ version): Prepare the
ground with holes circa 40 cm in diameter to a frost-free
depth. The C-C distance between the holes should be 94
cm. Fill the hole with a frost-resistant material so that the
depth of hole becomes 50 cm. Turn the bench upright and
position the supporting posts in the holes. Ensure that the
seat is level in position as well as level on all sides. The
distance between the seat’s front edge and the ground
beneath should be 46.5 cm. The supporting posts should
be cast in concrete, leaving a gap of 5 cm between the top
of the concrete and the ground surface to be filled in with
the surface material.
sid 3/7
Parco
