To restore factory defaults, select FD/Save on screen and press the minus (-) button. FD will
be displayed. To confirm, pull the trigger once and release. FD will stay on screen for a short
period of time and it will disappear when the process is completed.
FREQ. SHIFT
Other Settings Not Shown on Screen
It is the setting which enables you to change the operating frequency of the device. It is
used to eliminate the electromagnetic signals that the device receives from another
detector which operates in the same frequency range nearby or from the surroundings. If
too much noise is received when the search coil is lifted in the air, this may be caused by
the surrounding electromagnetic signals or too much sensitivity. In this case, first reduce
the GAIN. If the noise is not eliminated, you can choose to shift the frequency. The device
offers 5 different frequencies. Default setting is frequency 03.
To shift the frequency, keeping the trigger pulled back, simply press the plus (+) or the
minus (-) button.
IMPORTANT!
Frequency shift may impair performance. Therefore, it is suggested that you
do not shift the frequency unless it is required and operate it with the default settings.
LED Flashlight
It is the light used for lighting the scanned area while performing search at night or dark
locations. LED flashlight does not operate when the device is off. It is recommended to turn
it on when necessary since its operation consumes battery charge.
Keeping the trigger pulled back, press
the up button once to activate the LED
flashlight. Repeat the same procedure
to turn it off.
Page 12
Menu
