10
Nokia Intrusion Prevention with Sourcefire Appliance Quick Setup Guide
5.
Select the physical interface that will be used for the management interface:
Select an interface from the following for configuration:
1) eth1
2) eth2
3) eth3
4) eth4
5) quit this menu
Enter choice [1-5]:
The list of interfaces that you see depends on the NICs that are installed. Built-in
port names take the form eth
n
, while ports on NICs take the form eth-s
n
p
n.
For
example, eth-s4p1 is the ethernet port in chassis slot 4, port 1.
Type the number for the interface you want to configure. This interface should be the
same interface as you connected the management cable to.
6.
When prompted, enter the IP address and subnetwork mask length.
7.
When you see the following message, type
y
(the default option):
Do you wish to set the default route [ y ] ?
8.
When prompted, enter the IP address of the default router for this interface.
9.
When prompted to configure speed and duplex mode, you can either:
Configure speed and duplex mode, thereby turning off auto-negotiation. Do this
if you do not want to use Ethernet auto-negotiation.
Enter Return to bypass this step. Do this if you want to leave auto-negotiation on.
10.
When asked to confirm the interface parameters, type
y
.
The system will continue booting. When it is completed, the login prompt will
appear.
