Voltage
Voltage [V]
Condition
Higher extreme voltage
4.1
(fast charging)
HW Shutdown Voltages
Vmstr+
2.1 ± 0.1
Off to on
Vmstr-
1.9 ± 0.1
On to off
SW Shutdown Voltages
Sw shutdown
3.1
In call
Sw shutdown
3.2
In idle
Min Operating Voltage
Vcoff+
2.9 ± 0.1
Off to on
Vcoff-
2.7 ± 0.1
On to off
Power key and system power-up
When the battery is placed in the phone, the power key circuits are energized. When the power key is pressed,
the system boots up (if an adequate battery voltage is present).
Power down can be initiated by pressing the power key again and the system is powered down with the aid
of SW. The power key is connected to EM ASIC (N2200) via the PWRONX signal.
Modes of operation
Mode
Description
NO_SUPPLY
(Dead) mode means that the main battery is not present or its voltage is too low (below
EM ASIC master reset threshold) and that the back-up battery voltage is too low.
BACK_UP
The main battery is not present or its voltage is too low but back-up battery voltage is
adequate and the 32 kHz oscillator is running (RTC is on).
PWR_OFF
In this mode (warm), the main battery is present and its voltage is over EM ASIC master
reset threshold. All regulators are disabled, PurX is on low state, the RTC is on and the
oscillator is on. PWR_OFF (cold) mode is almost the same as PWR_OFF (warm), but the
RTC and the oscillator are off.
RESET
RESET mode is a synonym for start-up sequence. RESET mode uses 32kHz clock to count
the REST mode delay (typically 16ms).
SLEEP
SLEEP mode is entered only from PWR_ON mode with the aid of SW when the system’s
activity is low.
FLASHING
FLASHING mode is for SW downloading.
Clocking scheme
In BB5.44, two main clocks are provided to the system: 38.4MHz RF clock produced by VCTCXO in the RF section
and 32.768kHz sleep clock produced by EM ASIC N2200 with an external crystal.
32 k Sleep Clock is always powered on after startup. Sleep clock is used by RAPU for low-power operation.
SMPS Clk is 2.4MHz clock line from RAPU to EM ASIC N2200. In deep sleep mode, when VCTCXO is off, this signal
is set to '0'-state.
RM-529; RM-530; RM-584
System Module
Page 6 –10
COMPANY CONFIDENTIAL
Issue 1
Copyright © 2009 Nokia. All rights reserved.
