Nokia 100s, Installation Manual

Page: 39 / 111

Removing, Installing, and Replacing NICs
Nokia 60s and 100s Installation Guide 39
To remove, install, or replace a network interface card
Note
Because power to 60s and 100s appliances is automatically
disconnected when the chassis assembly is opened, you do not need
to manually disconnect the power for this procedure. Any servicing of
the unit, however, should be completed with the chassis assembly
fully removed from the appliance. Power is still active in the chassis
body and care should be taken when working on the power supply or
power supply wiring without disconnecting the power cord.
1.
Use Network Voyager to shut the system down.
For information about how to access Voyager, see
“Accessing Nokia
Network Voyager” on page 34 .
2. Use your fingers or a screwdriver to loosen the thumbscrews that hold the
chassis assembly.
00487
60s
Chassis assembly thumbscrews