Schritt 2: Anschluss der Elektronik
Bevor die Griffstange auf die vormontierten Fittings montiert werden kann,
müssen die Anschlusskabel verbunden werden.
Hierzu ziehen Sie vorsichtig die Platine ca. 5 cm aus dem rechten Fitting heraus.
Schließen Sie nun die beiden Stecker, welche aus der Griffstange herausragen,
an die Platine an. Anschließend schieben Sie die Platine wieder in das Fitting
zurück, so dass die Oberkante der Platine bündig mit der Oberkante des
Fittings ist (s. Bild 2.2).
Step 2: Electronics Assembly
In order for the handlebar to be mounted on to the pre-installed fittings, the
connector cables must be connected.
Please carefully slide out the circuit board from the right fitting by about 5 cm,
to connect both cables sticking out from the handlebar to the circuit board.
Then, please slide the circuit board back into the fitting, so that the upper
rim of the circuit board is aligned with the upper rim of the pipe fitting (s. pic. 2.2).
15
Summary of Contents for Sprintbook
