Features of Your Wine Cooler (Built-in)
Installation Instructions
Before Using Your Wine Cooler
• Remove all exterior and interior packing.
• Before connecting the Wine Cooler to the power
source, let it stand upright for approximately 2
hours.
• This will reduce the possibility of a malfunction in
the cooling system caused by handling during
transportation.
• Clean the interior surface with lukewarm water
using a soft cloth.
• The door on this appliance can be opened from
either the left or the right side. The unit is
delivered with the door opening on the left side.
Should you wish to open the door from the right,
follow the instructions ‘Reversing the door swing
of your appliance’.
Installation of Your Wine Cooler
• The appliance is designed to be built-in the
kitchen
cabinets.
• The appliance should be positioned in a well-
ventilated, dry room.
• Place your Wine Cooler on a position that is
strong enough to support it when it is fully
loaded. To level your Wine Cooler, adjust the
front leveling legs at the bottom of the Wine
Cooler.
• Locate the Wine Cooler away from direct
sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to
perform properly.
• Plug the Wine Cooler into an exclusive, easily
accessible plug socket. Any questions
concerning power and/or earthing should be
directed towards a quali
fi
ed electrician or an
authorized products service centre.
• To prevent the appliance from heating up,
ensure that an adequate ventilation gap is
retained and install a suitable thermal insulation
panel. An adequate
fl
ow of air to and from the
cooling system must be ensured.
• The appliance must be installed to all electrical,
plumbing, water and drain connections in
accordance with state and local codes.