NODEXON NX-6510S-20X4S2Q, Product Manual

Page: 13 / 51

Nodexon NX-6510S-20X4S2Q Series Switch Product Guide

Do not let any clothes touch a circuit board. An anti-static wrist strap can only prevent human static electricity from
damaging the circuit board, but cannot prevent any static electricity on clothes.
2.1.5 Laser Safety
Among the modules supported by the
NX-6510S-20X4S2Q
series switch, there are a great number of optical modules
that are Class
Ⅰ
laser product.
Precautions:

When a fiber transceiver works, ensure that the port has been connected with a fiber or has been covered by a
dust cap so as to keep out dust and prevent it from burning your eyes.

Do not stare at any fiber port.
Do not stare at any fiber port under any circumstances, as this may cause permanent damage to your eyes.
2.2 Installation Site Requirements
Install the
NX-6510S-20X4S2Q
series switch indoors. To ensure normal operation and a prolonged service life of the
device, the installation site must meet the following requirements.
2.2.1 Rack Mounting Requirements
Make sure the cabinet comply with the
se
conditions if the
NX-6510S-20X4S2Q
series switch is installed in the cabinet:

Install the switch in an open cabinet as much as possible. If you install the switch inside a closed cabinet, be sure
that the cabinet has a good ventilation and heat dissipation system.

Be sure that the cabinet is firm enough to bear the weight of the
NX-6510S-20X4S2Q
series switch and its
installation accessories.

Be sure that the dimensions of the cabinet is appropriate for installation of the
NX-6510S-20X4S2Q
series
switch that can reserve a certain space for the front, back, left and right panels for heat dissipation.

The cabinet should be properly grounded.
2.2.2 Ventilation Requirements
Maintain a minimum clearance of 200mm around the switch for ventilation. After various cables are connected, bundle
the cables or place them in the cable management bracket to avoid blocking air inlets. Dust the device every three
months to avoid blocking the ventilation openings.
2.2.3 Temperature and Humidity Requirements
To ensure the normal operation and a prolonged service life of the
NX-6510S-20X4S2Q
series switch, maintain an
appropriate temperature and humidity in the equipment room. The equipment room with too high or too low
temperature and humidity for a long period of time may damage the equipment.

In an environment with high relative humidity, the insulating material may have bad insulation or even leak
electricity. And sometimes the materials may suffer from mechanical performance change and metallic parts may
get rusted.