Noctua NH-P1| Installation manual
Scan this code to display multilingual manuals on
you mobile phone.
If there are residual traces of thermal paste or thermal pads on
your CPU, please clean them off first using the supplied NA-CW1
cleaning wipe. Then press 4 small dots (
~
2mm diameter) near
the corners plus 1 dot (
~
3-4mm diameter) of NT-H2 onto the
centre of the heatspreader.
Caution: Applying too much thermal paste will lower heat
conductivity and cooling performance!
While the NH-P1 has been designed for passive operation, its
cooling performance can be significantly improved by adding a
near-silent low-speed fan such as the NF-A12x25 LS-PWM. In
order to install the fan using the supplied fan mounting clips,
please first decide on which side of the cooler you would like to
install the fan and identify the correct hole set (1/2/3):
Fan setup
5
Warranty, support and FAQs
!
Even with high-grade products and strict quality control, the
possibility of defects cannot be eliminated entirely. Therefore,
we aim at providing the highest possible level of reliability and
convenience by offering a warranty period of 6 years and direct,
fast and straightforward RMA service.
Should you encounter any problems with your NH-P1, please
don’t hesitate to contact our support team ([email protected]).
Please also consult the FAQ section on our website:
www.noctua.at/faqs
Applying the thermal paste
3
Caution:
Please first take off the protection cover at the bottom
side of the heatsink.
Then put the heatsink onto the CPU and screw it to the screw
threads of the mounting bars.
Perform 2-3 turns on each screw, then repeat until both are fully
tightened.
Fastening the heatsink to the CPU
4
Caution: Gently tighten the screws until they stop, but do not use
excessive force (max. torque 0.6 Nm).
Then insert the tips of the fan clips into the correct hole set.
Place the fan on the heatsink and pull the clips over the fan to
hold it in place.
Connect the fan to one of the fan headers of your motherboard.
Make sure that the curved sides of the mounting bars are pointing
inwards.
Hole set 1
Hole set 2
Hole set 3
