3.
Insert the adjustable chuck with the
chosen accessory onto the flexible
driver, and rotate clockwise to
securely fasten, while keeping the
shaft lock button pressed. When tight,
release the shaft lock button and start
work!
How to set up the rotary tool stand
1
2
3
4
5
Your rotary tool stand comes disassembled in the kit, so locate both of the
pieces - the long metallic stick with a hook on one end (the stand), and the
plastic table-shaped block with a long screw in it (the table clamp). You can
see an image of the rotary tool stand in its assembled form on page 12.
Adjust the screw on the table clamp enough to fit the clamp on the edge of
your table. Once you've hooked it onto the edge of your table, tighten the
screw so that the clamp is secure and does not move.
Take the stand and screw it into the table clamp as tight as you can.
Adjust the stand height as necessary by pulling the stand as long as you
need, and rotating to secure the position.
Now your stand is set-up! Hang your rotary tool from the metal hook, and
you're good to go.
34
NB:
Try to keep the flexible driver more
or less straight at all times. If you do
need to bend or loop it,
make sure the
curve has a radius no smaller than 6
inches | 15cm to not damage the
driver.
