OPERATION
7
Speed Scrub
1701 Plus (12–00)
INSTALLING PAD DRIVER OR BRUSH
1.
Raise scrub head to transport position. Step down
firmly on scrub head lift pedal to raise (Figure 10).
NOTE: To prevent scrub head skirt damage, keep
machine in transport position when pad driver or brush
is not installed.
FIG. 10
2.
Select a recommended pad or brush that best
meets your cleaning needs.
IMPORTANT: Consult an authorized distributor to
assist you in choosing the correct pad or brush for
your specific cleaning need.
3.
Attach pad to pad driver before mounting driver to
motor hub. Secure pad with plastic centerlock ring
(Figure 11).
FIG. 11
4.
Turn on key switch (Figure 12).
FIG. 12
5.
Place pad driver or brush on floor in front of
machine. While tilting the machine backwards,
center the scrub head down over the pad driver
(Figure 13).
FIG. 13
6.
Release the brush lift pedal from transport position
while holding scrub head off pad driver
(Figure 14).
FIG. 14
7.
Gradually lower scrub head down on pad driver or
brush, you will feel motor hub fall into position. Pull
the brush triggers until motor hub engages the
driver/brush. If pad driver/brush doesn’t engage
within a few seconds, realign scrub head down
over pad/brush and try again (Figure 15).
NOTE: Pad driver/brush will not engage motor hub
with machine in transport position.
FIG. 15
NOTE: Before installing pad driver or brush make sure
mounting surface is clean. A clean surface will ease
pad driver removal later.
