OPERATION
Magna Twin
t
1600/2200/2600 (09–01)
7
MACHINE COMPONENTS
1
12
8
15
6
7
4
5
3
2
10
11
9
14
13
16
17
1. Handle
2. Attachment Tool Elbow
3. Vacuum Hose
4. Brush Housing
5. Vacuum Bag Housing
6. Brush Height Adjustment Knob
7. Brush
8. ON/OFF Switch
9. 15m (50 ft) Power Cord
10. Door Latch/Upper Cord Hook
11. Rear Door
12. Lower Cord Hook
13. Handle Release Foot Latch
14. Exhaust Vent
15. Rear Wheels
16. Serial Number Tag
17. Brush Circuit Breaker (bottom side)
MACHINE SETUP
1.
Carefully check carton for signs of damage.
Report damages at once to carrier.
NOTE: If rear door has become misaligned during
shipment, loosen nuts at hinge, realign door and
re–tighten nuts.
2.
Vacuum is shipped fully assembled. A paper
vacuum bag is factory installed and is ready for
operation.
Attachment Tool Kit is sold separately. If cleaning
with attachments see Attachment Tool Operation.
3.
Plug power cord into grounded wall outlet
(Figure 1).
Grounded Outlet
Grounding
Edge/hole
Grounded
3 Hole Outlet
Ground Pin
(120V)
(230V/240V)
FIG. 1
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1.
Always check to ensure a vacuum bag is installed.
Replace bag if necessary (See Vacuum Bag
Removal/Installation).
2.
Lower handle to operating position by depressing
handle release foot latch (Figure 2).
