OPERATION
Speed Scrub
t
2001 Battery (11–01)
13
A
B
FIG. 23
3.
Keep battery tops and terminals clean and dry.
To clean batteries:
a.
Mix a strong solution of baking soda and
water.
b.
Brush solution sparingly over battery tops,
terminal and cable connectors.
NOTE: Do not allow baking soda solution to enter
battery cells.
c.
Use wire brush to clean terminal post and
cable connections.
d.
After cleaning, apply a coating of clear battery
post protectant to terminals and cable
connections.
4.
Check for loose or worn cables. Replace if worn.
TRANSPORTING MACHINE
When transporting machine by use of trailer or truck,
be certain to follow tie–down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1.
Remove squeegee from machine and raise scrub
head. Leave pad or brush installed.
2.
Load machine using a recommended loading
ramp.
3.
Position front of machine up against front of trailer
of truck. Once machine is positioned, lower brush
head.
4.
Place a block behind the drive wheel and the rear
casters.
5.
Place tie–down straps over top of machine and
secure straps to floor. It may be necessary to
install tie–down brackets to the floor of your trailer
or truck.
STORING MACHINE
Store machine in a dry area in the upright position.
Before storing machine be certain to flush tanks and
drain machine of all water. Remove recovery tank lid
to promote air circulation. Raise pad driver and
squeegee off floor to prevent damage.
ATTENTION If storing machine in freezing
temperatures, be certain to drain machine of all
water. Damage due to freezing temperatures is not
covered by warranty.
ATTENTION: Do not expose machine to rain; store
indoors.
RECOMMENDED STOCK ITEMS
Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
