Noblelift FE4P50N, Operation And Maintenance Manual

Page: 64 / 105

63
cloth on fork prong forward dead corner.
·Pay attention for road surface slide or cave in.
·To lower fork after parking perfectly, it is very dangerous to lower fork during
traveling.
·Do not jump off vehicle.
·When get off forklift, you have to face vehicle and take favour of footboard.
·Slow down first and step brake pedal down and standstill and put gearshift on “N”.
·Parking vehicle at place where is
convenient to other vehicle and operating as follow:
(a) Pull backward the parking brake handle enough to its position,actuate the parking
brake.
(b) Let fork lower to make it touch ground.
(c) Turn ignition key to“off”position.
(d) Take off key and keep it carefully.
(e) Be careful to get on or get off vehicle.
(f) Parking forklift
·When get off forklift, pull brake handle up and to tilt mast forward. Lower fork on
ground. When parking on ramp, block forklift by wedge.
·When leaving forklift, take ignition key
9. Usage of battery
(1) Charging battery
To choose right charger according to instruction of operating manual.
(a) Keep liquid on normal level.
·Keep liquid level on normal situation to prevent battery from being over-hot or being
burn out.
·If electrolyte is not enough, the life-span of battery will be shorten
(b) Infuse distill water.
(c) Do not overcharge.
(d) Charging place shall be ventilated enough.
·Battery charging shall be at ventilated and dry place.
(e) Open bettery cover.
·There is hydrogen to be geverated when charging,so and please open bettery cover.
(f) Check terminal, cable and connector.
·Before charging, check connector and cable to ensure there is no injury
·Not charging under the situations as follow:
—Connector terminal has been injuried.
—There are rust and abrasion in Turminal and cable.
These situations will lead spark to burn and to explode.
(g) Charge after turning off ignition key.
(h) Check proportion
Before charging, check each cell for electrolyte proportion to detect for abnormal condition to
prevent certain accident happen.
(i) When pulling out or insert power connector, hold connector or handle not the cable.
·Do not pull out cable.
·If cable and connector failure, please inform manufacturer to replace by new one.
(j) Break up charging procedure