11
07610-004-45-09-D
INSTRUCTIONS
INSTALLATION
This machine is supplied with detergent and rinse-aid chemical feeder pumps.
Locate the open ends of the chemical tubes with the tube stiffeners and place each
one in the appropriate container.
A. Red Tubing = Detergent B. Blue Tubing = Rinse-aid
Chemical feeder pumps need priming when the machine is first installed or if the
chemical lines have been removed and air was allowed to enter.
CAUTION!
Water must be in the sump and wash tank before dispensing chemicals.
1.
Verify that the proper chemical tube stiffener inlet is in the proper container.
2. To prime the detergent pump, press the I button until the chemical is seen
entering the wash tank. The amount of detergent might need to be adjusted
depending on water quality and type of detergent.
3. To prime the rinse-aid pump, press the II button and hold for one minute. The
amount of rinse-aid might need to be adjusted depending on water hardness
and results.
4. Refer to the next section for instructions on adjusting the amount of chemicals
being dispensed.
PRIMING CHEMICAL
FEEDER PUMPS
WARNING!
Some of the
chemicals used in
dishwashing may cause
chemical burns if they
come in contact with skin.
Wear protective gear when
handling these chemicals.
If any skin comes in
contact with these
chemicals, immediately
follow the instructions
provided with the
chemicals for treatment.
PREPARING
CHEMICAL
FEEDER PUMPS
!
WARNING
!
CAUTION
1 5 5
F
R E A D Y
DETERGENT PRIME
1 5 5
F
R E A D Y
RINSE AID PRIME
