Nobis A13 C ZENITH, Installation, Use And Maintenance Manual

Page: 27 / 36

Use and Maintenance Manual model “A13V - C ZENITH & A13 V PLUS ZENITH”
27
ENGLISH ENGLISH
13 PHASES CONCISE DIAGRAM
PHASE DESCRIPTION
- The phase starts to pre-heat the re
sistor and the pellet starts to
fall in the brazier.
- The pellet switches on by taking ad
vantage of the heat in the inlet air
which passes by the duct of the
incandescent resistor.
- Pellet loading restarts and the
flame develops.
The appliance has terminated the
switch on phase and
goes to the working power set.
The desired ambient temperature is
reached.
The cleaning phase is enabled of
the brazier without movement of the
cleaner (periodic function).
The brazier cleaning phase is run -
ning with the cleaner enabled. The
appliance switches off and switches
back on autonomously.
Switch on is required after a cooling
phase.
Having reached this condition,
the appliance automatically starts.
The appliance is in the switch off
phase and the cooling
phase has not yet
terminated.
The appliance is OFF and all the
motors are disabled.
SWITCH ON
WORK
SAVING
BRAZIER CLEANING
CLEANER ENABLED
FINAL CLEANING
OFF
WAITING FLAME
FLAME PHASE
RESTART
PHASE DESCRIPTION
Ambient setting in MAN
therefore the appliance only works
with the power to the fireplace
set (never going to
saving)
MAN WORK
14 FUNCTIONS CONCISE DIAGRAM
Edit the data highlighted using the keys
Confirm the data changed using the key
Repeat the same operation to set the following pa-
rameter;
OK
12.6 DISPLAY CHANNELLING STATUS
To display the channelling status, from the STAND-BY
status, press the key .
The display screen follows:
SET RH
CHANNELLED
AMBIENT
TEMP. RH CHAN-
NELLED AMBIENT
SPEED
RH VENTILATION
When the POWERFUL function is enabled, in display
status, you can also see that channelling is in this
mode, as in the figure below.
Having confirmed setting of the
RH channelling, confirm with the key and re -
peat the same sequence of operations for the
LH channelling.
OK
Edit the data highlighted using the keys
Confirm the data changed using the key
Repeat the same operation to set the following pa-
rameter;
To return to the STAND-BY screen, use the
key , confirming all the settings.
OK
OK
SET LH
CHANNELLED
AMBIENT
TEMP. LH CHAN-
NELLED AMBIENT
SPEED
LH VENTILATION
Setting the ambient temperature for
channelling, this is only managed if the TEMPERA-
TURE CONTROL function is enabled, previously seen,
ENABLE T.EXT in SET SETTING disabled in the CHAN-
NELLING menu.