Nobile F400 -SI, Mounting And Operation Instructions, Page: 4 / 4

Montage-/ Betriebsanleitung
Mounting-/Operation Instruction Fernbedienung für Präsenzmelder F400-SI
Remote control for LED High Bay F400 -SI
Seite
4 von 4
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de rev. 0.1 – 03.05.2022
Functions
Button Description Button Description
BRIGHTNESS
Set brightness level of the light during occupancy
(70% / 80% / 90% / 100%)
STAND-BY
DIM
Set brightness level of the light during
non-occupancy
(0% / 10% / 30% / 50%)
SENSITIVITY
Set Presence sensor sensitivity
(20% / 50% / 75% / 100%)
To enter Presence sensor sensitivity test mode:
hold time is 2sec, Standby time and Daylight
sensors are deactivated
(to quit this mode, press the Auto button)
HOLD TIME
Length of time before the lamp goes to Stand-by
mode when no presence is detected
(10sec / 1min / 5min / 10min /
15min / 20 min / 30 min / 60 min)
STAND-BY
TIME
Length of time that the lamp stays in Stand-by
mode before it switch Off when no presence is
detected
(+∞ / 1min / 30min / 60 min)
To enter daylight sensor configuration
(disabbled by default)
DAYLIGHT
SENSOR
Daylight level threshold of the sensor
Select the surrounding lux value as the daylight
threshold
Deactivate the upper threshold of the daylight
sensor
Daylight sensor lower threshold (lux Set-point On)
Daylight sensor upper threshold (lux Set-point Off)
Sets lamp to permanent On or Off and disable the
sensors (to quit this mode, press the Auto button)
To enable the sensors and all previously set
parameters prior permanent On/Off
LED indicator will display the set parameters Reset parameters to the dip switch sensor setting
Navigation keys up and down during parameters
setting
Navigation keys left and right during parameters
setting
Confirmation button
Upload the set parameters to the sensor
(During uploading, aim the remote at the target
sensor. The lamp connected to the sensor will blink
to confirm sending)
Preset scene modes