Montage-/ Betriebsanleitung
Mounting-/Operation Instruction
Fernbedienung für Präsenzmelder F400-SI
Remote control for LED High Bay F400 -SI
Seite
3
von
4
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de rev. 0.1 – 03.05.2022
EN
Congratulations on your purchase of this nobilé-product!
You have decided on a high-quality product which is manufactured with the utmost care and subject to several quality controls. Safe use of the
product is only guaranteed if each instruction is followed accordingly. In case of damage caused by non-observance of these instructions the warranty
expires. The installation and electrical connection must be done by an authorized expert (e.g. electrician) in compliance with existing standards and
local code. Prior to any installation or maintenance work, mains must be disconnected. Before putting in operation, make sure any component of the
entire installation does not bear a risk of life. According to common practice, please perform a standard function test, before installing. To make
maintenance work possible, the lighting system should be accessible after installation (auditable).
Motion Sensor
with sufficient natural light, the
lamp will not switch-on even a
presence is detected
with insufficient natural light, the
sensor will switch the lamp ON
when a presence is detected
After the set Hold-time, the lamp
will dim down to the set Stand-by
level when no presence detected
The lamp will switches off
automatically after the Stand-by
time elapses
Daylight Sensor
with insufficient natural light, the
sensor will switch the lamp ON
when a presence is detected
with sufficient natural light, the
lamp will not switch-on even a
presence is detected
Mode Settings
Application
Mode
Brightness
Sensitivity
Hold Time
Stand-by Time
Stand-by Level
Daylight Sensor
Indoor
Mode 1
100%
75%
5 minutes
30 minutes
30%
Indoor
Mode 2
100%
75%
1 minute
+∞
30%
Indoor
Mode 3
100%
75%
5 minutes
30 minutes
30%
30 Lux
Outdoor
Mode 4
100%
75%
1 minute
+∞
30%
(30 Lux / 300 Lux)
Technical Specification
Battery
2 x AAA
Operation Frequency
5.8GHz
75MHz
Transmission Power
<0.2mW
Sending Range
max. 15m
Ambient Temperature Ta
0 ~ 50°C
Dimension
123 x 70 x 20 mm
Warning!
Remove the batteries from the device when the remote will not be use in 30 days.