REVERSE OSMOSIS SYSTEMS RO 4... /E /EL - INSTRUCTIONS MANUAL
s.r.l.Milano - ITALY
Page 7 of 25
ro4e_mi-r10.doc -
r. 10
4. Installation
4.1. Room
conditions
These units do not include visible moving or specially noising parts (see also the "noise
monitor chart" attached to the special instructions of high-pressure pump). There are not any
points which reaches high temperature.
4.2. How to remove packaging
The packaging consist of a wooden crate which contains the reverse osmosis system, skid-
mounted.
Open the wooden crate removing, first, the cover and, then, the sides. Keep the cards and
everything contained inside the packaging.
4.3. How to move and lift the unit
Some of the pipes of the plant are made in
plastic material, hence they can be easily
damaged. Do not lift and/or move the unit by
any part of the plant. Use only the hooking
rings, placed on the upper part of the skid to
lift the unit, and ropes or chain of adequate
size and dead-weight capacity.
(see
DIMENSIONS/WEIGHT diagram)
Fork-lift or
other suitable equipment can be used,
checking to warrant correct balance and
stability during the movement. Insert the forks
on the front of the skid as shown on sketch.
4.4. Placing
Place the unit on a perfectly flat surface.
Follow the directions of the dimensional drawing for the correct placing of the unit, according
to the dimensions of the available room and the required room for service and maintenance.
Not any anti-vibration devices is required, hence the unit can be directly placed on floor.
