9
NUTV5 / NUTV5-S: Amplifier's gains and crossover settings
Your HS4 amplifier’s control panel was already preset to optimally power the N5 Full
-range speakers you have
purchased. Since the HS4 is a very powerful amplifier we suggest keeping these factory settings as is.
Under or overpowering your speakers might cause them
thermal (burnt voice coil) and/or mechanical failure
(torn surrounds or spiders).
And these damages
are not covered by your warranty
.
Below you will find our recommended factory gains and crossover settings for your NUTV5/NUTV5-S
system.
Rear’s
crossover is set on
LPF
(low pass) for the NSUB subwoofer, should you choose to add one in the
future
Front’s
crossover is set on
FULL
(full range) for tower speakers
In case you decide that you do need to change any of these settings, please make sure you know what you are
doing or have a professional set them for you. The amplifier’s settings and controls are located on the front
panel beneath a protective gasket cover. Remove the six screws from the center panel to access the controls
and make the adjustments.
Make sure you replace the cover back exactly how it was otherwise you might
compromise the amplifier's waterproof ratings. We remind you that water damages are not covered by
your warranty.