15
4.
DO NOT
be tempted to bridged the HS4 to power two N5 speakers. It will lead to burnt voice coils
and will void the warranty.
5.
Now that everything is hooked up as it should, let's test your system. Turn your controller on,
the
amplifier's power indicator light will first turn RED and If all connections are OK, within 2-5
seconds the light will
turn BLUE. In case the light remains red it means that the amplifier is in
protection mode, due to a short circuit, or inadequate voltage, either too high or too low. In this
case
see page 18 for troubleshooting
6.
Play some tunes to make sure all is working as it should.
7.
Now you can go ahead and mount the amplifier
in a dry and well-ventilated location where it
will remain dry at all times.
NUTV5-S QUAD: Amplifier's gains and crossover settings
Your HS4 amplifier’s control panel was already preset to optimally power the N5 Full
-range speakers and
NSUB subwoofer you have purchased. Since the HS4 is a very powerful amplifier we suggest keeping these
factory settings as is.
Under or overpowering your speakers might cause them
thermal (burnt voice coil) and/or mechanical failure
(torn surrounds or spiders).
And these damages
are not covered by your warranty
.
In the next page you will find our recommended factory gains and crossover settings for your NUTV5-S QUAD
system.
Rear’s
crossover is set on
LPF
(low pass) for the NSUB subwoofer
Front’s
crossover is set on
FULL
(full range) for tower speakers