NKT Photonics SuperK CONNECT, Product Manual

Page: 18 / 40

Mounting the CONNECT
18
Figure 7 SuperK CONNECT mounting orientations – visible port
Procedure 2 Installing an FD module
Install the FD module ( Figure 8 ) following the steps below.
Figure 8 Fiber delivery unit – input coupler to FC/APC output
1. Ensure the SuperK laser is still off and if possible, disconnect its power
source.
2. Insert the FD coupler into the CONNECT output port until its collar is flush
against the SuperK CONNECT. To insert the coupler completely, the key on
the collar of the coupler must be aligned with the slot on the CONNECT
output aperture as shown in
Figure 9 .
Vertical mounting Horizontal mounting
FD input coupler