FF01/Rev.01/EN
【
Soldering
】
・
After inserting the lead wire into the terminal hole, use a soldering iron to ensure a secure connection.
Incomplete soldering may cause overheating and fire during use.
・
Note that if soldering is performed while the terminal is facing up, flux may enter the interior of the switch. Perform soldering carefully.
・
The solder resistant temperature is 390°C. Complete the soldering within four seconds.
【
Usage Environment
】
・
The product is designed for indoor use.
・
Do not install the product in locations subject to frequent splashing of water.
・
If the product becomes wet, wipe off with a dry cloth. Using a switch exposed to water may result in water entering the inside; if the
water inside freezes, the switch may not function properly.
・
When using the product in environments subject to accumulations of dust and dirt, remove such accumulations from the area around
the switch before use. Accumulated dust and dirt may affect switch function.
【
Routine Care
】
・
Use a dry cloth to wipe dirt from the actuator. If the actuator is very dirty, wipe with a cloth dampened with a small amount of neutral
detergent, then wipe dry. (Actuator material: Fiber-reinforced PBT)
4.
Installing the Switch
(1)
Remove the round nut from the switch main body.
(2)
With the notch in the O-ring aligned with the anti-rotation tab on the switch main body, insert the switch body into the panel. In
this step, align the anti-rotation tab on the switch main body with the anti-rotation keyway on the panel.
(3)
Using the nut wrench (AT119), tighten the round nut from the back of the panel to the recommended tightening torque of 785
mN·m.
