4
frequency of power supply match the power requirements of product.In power supply
and voltage fluctuation large areas,we suggest you to use 110V or 220V or use voltage
regulator to supply power.After electrical connection,this product will have a few
seconds self-check action, self-check finished can be used.
Important:It is essential that Yellow/green double color wire is correctly earthed and
that electrical installation conforms to all relevant standards
DMX Connection method
DMX control signal connection must be made with a two core-screened cable,with
each core having at least a 0.5mm diameter.Please use the product's signal cable OUT
and IN as connection.The signal OUT and IN cables connection shown as above
picture.
Note:Please do not connect the signal cable OUT and IN in other way except above
shown.
This product accepts digital control signals in protocol DMX512(1990).The
amount of lighting fixtures connected in parallel is no more than 32.Connect the
DMX controller's
Output
to the first lighting fixture's
Input
cable with a 2 core XLR
signal cable(Shown as above ),connect the first lighting fixture's
Output
cable to the
second lighting fixture's
Input cable
and connect the rest light fixtures in the same
way.Eventually,connect the last lighting fixture's Output cable to a DMX terminator
Under DMX-512 signal control mode,the last lighting fixture's DMX Output must be
connected with a DMX terminator.This prevents electrical noise from disturbing and
corrupting the DMX control signals.The DMX terminator is simply an XLR
connector with a 120
Ω
(ohm) resistor connected across pins 2 and 3,which is then
plugged into the output socket on the last projector in the chain.Then connections are
illustrated above.
