Nixie Clock RSH27, Manual

Page: 4 / 18

RSH27 Nixie Tube Socket with LED
-
Pull the tube out of the socket.
-
The following step only is necessary if you want to use the floor lighting feature by a LED:
Solder the LED to the board. It must be assembled from the top side, of course. The distance between
LED and tube bottom should be kept small. Note the drawing “Section drawing of the socket with IN-8
tube” below for that.
-
Record the position of the anode and the cathode of the LED. You can choose the direction freely.
-
Solder the connection wires from the bottom side to the corresponding solder pads of the socket. The pin
markings at the bottom side of the socket match to a IN-8 Nixie tube in case you use the standard
alignment.
-
Put the tube into the socket.
Page 4 of 18