Blink code
Description
Solution/cause
0x
Transport lock (GPRS OFF, measurement
OFF)
If the ALOHA transmission mode is initiated by
the button or solenoid switch, the NivuLog
Easy switches back into "RUN" mode (GPRS
ON, measurement ON).
1x
Last connection OK
2x
Last transmission faulty
Try again later
4x
Standby (GPRS ON, measurement OFF)
See "transport lock"
6x
Offline (GPRS OFF, measurement ON)
See "transport lock"
7x
Network block/no matching provider
l
Improve position of the antenna
l
Check whether the device is located in
the coverage area of a service provider
that is supported by the integrated SIM
chip (www.nivus.com)
l
Lift the network block (see
"DeviceConfig Manual" - upon request)
8x
No GSM network
l
Try again later
l
Improve position of the antenna
10x
No GPRS connection
Improve position of the antenna
11x
No myDatanet server accessible
l
Check whether port 51241 is enabled on
the Device to Web server
l
Try again later
12x
Faulty SIM chip
Contact support
Error/status codes
Status
LED
Description
Flickering
Establishing connection
Lights up
GPRS connection established or button/solenoid switch actuates
Off
Normal measuring operation according to configuration until the next transmission
Operating statuses
9.1.1.2 Buttons
The button can also be used to initiate the ALOHA transmission mode or to instruct the NivuLog Easy to
immediately give out the error/status code.
User action
Device response
Operation after releasing the button
Press briefly for
approx. one second
Status LED illuminates
Error/status code is displayed (see "Status
LED" on page 35)
Press and hold for
five seconds
Status LED flashes three times and then
remains on
ALOHA transmission mode
36 of 73
NivuLog Easy - Rev. 05 as of 02.07.2012
