5
EN
General Pneumatic Tool Safety Warnings
WARNING
Use the tool with proper air pressure.
If the air pressure is high, the rotation speed and reciprocation frequency become faster, causing damage such
as damage or accelerated wear. Also, unexpected accidents could occur.
Connect the tool to air piping.
In some factories, other than air piping, there may be other piping such as oxygen, nitrogen, gas, etc. Before
connecting to piping, make sure it is the correct piping.
Do not start the tool carelessly.
Turn off the operation switch, then attach the Connecting Hose to the tool.
When attaching, removing, and maintaining accessories, make sure to detach the Connecting Hose from the
tool.
Be cautious about exhaust.
Pneumatic tool exhaust contains oil and drainage, etc. Be careful about the exhaust direction so that the exhaust
does not directly hit people nearby.
Do not allow sources of electricity to touch the tool.
The pneumatic tool is not insulated against contact by electric sources. Because there is a risk of electric shock,
do not allow sources of electricity to touch the tool.
CAUTION
Handle the tool with care.
Rough handling could cause accidents or malfunctions. Do not exert an impact on the tool by throwing or
dropping it.
Handle the Connecting Hose with care.
Do not carry the tool by holding the Connecting Hose, and do not pull the Connecting Hose to remove it.
Safety Warnings for PNEUMATIC NEEDLE SCALER
The following warnings are those required to be displayed as instructed by ISO11148-4
General Safety Rules
WARNING
For multiple hazards, read and understand the safety instructions before installing, operating, repairing,
maintaining, changing accessories on, or working near this tool. Failure to do so can result in serious bodily
injury.
Only qualified and trained operators should install, adjust or use this tool.
Do not modify this non-rotary percussive power tool. Modifications can reduce the effectiveness of safety
measures and increase the risks to the operator.
Do not discard the safety instructions; give them to the operator.
Do not use this tool if it has been damaged.
This tool shall be inspected periodically to verify the ratings and markings. When a label/nameplate is
damaged, worn or missing, contact the sales agent through which you have purchased your tool or NITTO
KOHKI CO., LTD. directly for a replacement.
TQ15408-0̲JT-16̲en.indb 5
2017/11/21 8:38:13
