Nitto Kohki AMB-0307, Instruction Manual

Page: 5 / 14

4
INSTRUCTIONS FOR
THIS TOOL
About Your Tool
WARNING
●
Always turn off the air supply and supply hose
beforehand whenever replacing Indexable Insert.
●
To replace the Indexable Insert after using, do
not touch with bare hands as the Indexable
Insert and holder are heated at high temperature.
●
Use our original Indexable Inserts.
●
Do not use the worn or damaged Indexable Insert.
1. USAGE
This tool is for chamfering workpieces with a
Indexable Insert.
2. CHECK THE CONTENTS OF THE PACKAGE
Check the contents and make sure that the tool
does not have any damage which may have
occurred during transportation. The contents should
correspond to the list as follows. In case of damage/
missing parts, please contact the sales agent from
whom you purchased the tool.
AMB-0307
Package Contents Qty Check
MINI BEVELER 1
Knob 1
Hex. Socket Screw Key 4 1
Indexable Insert with Hole 12.7 1
Hex. Socket Screw Key 3 1
Hex. Nut M8 2
Hex. Socket Set Screw 8 × 25 Special 2
Spanner T-15F 1
Bushing R3/8
×
NPT3/8 1
Instruction Manual 1
Caution for Use 1
AMBL-0307
Package Contents Qty Check
MINI BEVELER 1
Knob 1
Hex. Socket Screw Key 4 1
Indexable Insert with Hole 12.7 1
Hex. Socket Screw Key 3 1
Hex. Nut M8 2
Hex. Socket Set Screw 8 × 25 Special 2
Spanner T-15F 1
Bushing R3/8 × NPT3/8 1
Instruction Manual 1
Declaration of Conformity 1
Caution for Use 1
3. NAME OF PARTS
4. AIR SUPPLY
4-1. Air Pressure
Adjust air pressure with the air regulator to the
appropriate level for the pneumatic tool used.
Air pressure that is too low will stop the tool from
operating at full capacity.
Air pressure that is too high may cause damage to
the tool.
4-2. Air Line (Fig.1)
Use a 9.5 mm (3/8”) I. D. connecting hose between
the compressor and the tool.
Drained water, etc., if flown into the tool, could
cause tool failure. Install an air filter between the
compressor and the tool.
Air Regulator
Oiler
Air Filter
Compressor
Lubrication
Tool
9.5mm (3/8”) I.D.
Hose
Cupla
Fig. 1
4-3. Lubrication
Install an oiler between the compressor and the tool.
Use the machine oil ISO VG-10. Failure to lubricate
as required may result in damage to the tool. Use of
oil that is too thick will reduce the performance of the
tool.