Nitta PolySprint NPS-0310H1, Operation Manual

Page: 4 / 24

- 3 -
1 Safety Precautions- Continued-
Confirm that the power source used is within the designated specifications
of the PolySprint
™
Heat Press.
Use beyond the designated specifications may cause fire or electric shock.
Type Power Source
NPS-0310H1 100V
－
120V 50/60Hz
NPS-0310H2 200V
－
240V 50/60Hz
Connect the main plug correctly to the socket outlet.
The power cable of the press uses an earth connection plug. Connect the main
plug correctly into an earth connection outlet to prevent electric shock.
Always use anti-heat gloves when handling the Heat Press to prevent
burns.
A label “Hot!” is on the top and bottom plates of the press to warn against high
temperature.
Do not touch any part of the press, other than its handle, even with
anti-heat gloves on while the press is being heated or while it is still hot
after using.
Metal edge portions beyond the handle shaft can exceed 100 ℃ , which may
cause burns even with anti-heat gloves on.
Disconnect the main plug from the socket outlet immediately after use.
An operator should pay attention so that others do not touch the press
carelessly and get burned before the press has cooled down.
It takes about two hours for a heated press (200°C) to cool down to 40°C in the
room temperature of 25°C once it has been unplugged.
Do not use the Heat Press on a flammable material.
Always use a pre-setter supplied by Nitta .
Use of any other product may cause fire.
WARNIN
G
WARNIN
G
WARNIN
G
WARNIN
G
WARNIN G
WARNIN
G
WARNIN
G