INSTALLATION
MOUNTING
LITEPANEL T18 may be set up on a solid and even surface. The unit can also be mounted upside down to
ity and be able to support a weight of 10 times of the unit’s weight.
When carrying out any installation, always comply scrupulously with all the regulations (particularly re-
• Install the projector at a suitable location by means of the mounting bracket.
• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-
ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.
• Adjust the projector and use the knob to slightly release or tighten the locking mechanism of the
bracket if is necessary.
7
Moun
Ɵ
ng Clamp
Double-
Bracketed Yoke
Safety Cable
Bracket Adjustment
Knob x 2
Barn Doors
SOUND MODE
In music mode, via its integrated microphone, the unit can be controlled by music with a clear rhythm in
the bass range. If the music control should not work optimally, increase the volume or reduce the distance
• Press the button MENU so many times until the display shows Snd.
•
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
Sens
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) u0 - u100.
MANUAL COLOR
This mode allows to combine the colors red, green and blue (r, g, b).
• Press the button MENU so many times until the display shows U-- , then press the button ENTER.
• Select the color r, g, b through the buttons UP/DOWN.
• Using UP/DOWN button, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
DIMMER
shows dIM
• Press the button UP/DOWN to select OFF - dIM1 - dIM2 - dIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
LINKING
master unit. Use standard DMX cables to daisy chain your units together via the DMX connector on the
are connected in a chain.
DMX CONFIGURATION
3CH - 5CH - 9CH - 13CH ), then press ENTER.
• Press the button UP/DOWN to select the desider value (001 - 512), then press the button ENTER to con-
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
LITEPANEL T18
10
