Measurement is
interrupted once and
cuff is deflated and
inflated again.
Cannot make great
number of
measurements.
Cannot complete the
measurement.
Blood pressure is
different each time. The
reading is extremely
low (or high).
Pulse rate is too low
(or too high).
Measurement result is
not stored.
The power is
automatically turned
off.
ERROR SYMBOL/SYMPTOM
This does not indicate a
problem.
Do not move during
measurement.
Use alkaline batteries to
increase battery life.
Replace all four batteries with
new ones.
Measure with the correct
posture.
See TIPS ON TAKING YOUR BLOOD
PRESSURE.
Remain still during the
measurement.
Measure again after resting for
more than 5 minutes.
Confirm the memory bank
number.
Make sure desired memory bank
is selected before turning off the
monitor after a measurement.
When is displayed the result
will not be saved.
This does not indicate a problem.
The instrument automatically
turns off 3 minutes after a
measurement or 30 seconds
after memory display.
When noise is detected or diastolic
blood pressure is low, the cuff is
deflated and inflated again.
Did you move during measurement?
Are you using alkaline batteries?
Have the batteries run down?
Are you measuring with correct
posture?
Blood pressure readings constantly
vary with time of measurement and
nervous condition.
Did you move during the
measurement?
Did you take measurement
immediately after exercise?
Is it the right memory bank?
Did you select correct memory
bank number after the
measurement?
Have you left the instrument
untouched after the measurement?
If you cannot get correct measurement with the methods above, do not tamper with the internal mechanism.
Contact your dealer. If the unit malfunctions, please return it to the dealer or an authorized service representative
for service according to the warranty.
ERROR DISPLAYS AND TROUBLESHOOTING
CAUSE / CHECK POINT
REMEDY
- 19 -
